As I am pretty new in broadcast audio setup configuration, this question might be very easy to answer...(I hope):
I configured the desklink card as described in an other place in this forum. hard- ans software is working fine so far.
Now is my problem, that I have an SDI input on the output of the desklink card as soon as I start the caspar cg server module. I like to have it in that way, that the input signal on desklink is routet over casper software (client) and the edited content is at the output of desklink. now I see the original picture from desklink input under the edited signal from caspar client. keyer is set to internal. If I switch to external, the problem described above is solved, but embedded audio is gone (to somewere...).
I am pretty shure that this is a little configuration issue, and I would be very happy to get some hints from you, guys!
best regards, Daniel